Cannabis Hardware B Zero versus TiTi DIY-Inspired Heavy Bundle Kits: What’s the Difference⁉️
The TiTi DIY-Inspired Injector Bundle curated exclusively by VGoodiez is the most budget friendly coil-driven currently available on market. Both Heavy Bundle Kits are derived from the 19mm Cannabis Hardware Shovelhead Post and are compatible with all PID controllers listed on the VGoodiez. However, there are some differences that we’ll discuss more in detail.
- Machined Cannabis Hardware Shovel Head Post - bored to increase airflow capacity
- Utilizes Cannabis Hardware 20mm coil
- More upgradeable options
- Has slightly more mass than TiTi
- Efficient at a lower PID controller temperature
- Machined inner lips to hold screens more securely
- Utilizes stock Cannabis Hardware Shovel Head Post
- Choose between Auber or Disorderly Conduction coils
- Utilizes stock Cannabis Hardware Shovel Head Post
- Choose between Auber or Disorderly Conduction coils
- Utilizes stock Cannabis Hardware Shovelhead post
- Choose between Auber or Disorderly Conduction coils
- Auber can’t support handle, cheapest bundle
- Disordely Conduction can accept handles
- Limited and/or no upgradeable options
- Operates at higher temperature
- Top, Bottom basket screens are friction-fitted to an 19mm Cannabis Hardware Shovel Head Post
As a reminder, any Heavy Bundle Kit or Cannabis Hardware Head Assembly ordered through VGoodiez is built and undergoes burn-off for your safety and convenience. If you would like your kit to arrive unassembled, please leave notation during checkout.
“The TiTi DIY-Inspired Injector Bundle curated exclusively by VGoodiez is the most budget friendly coil-driven currently available on market.’’’
Before initial operation, follow these steps:
- Visually inspect top and bottom portion of injector head, making sure screens are fastened properly
- After inspection approval, tightly hold onto coil/injector head assembly and gently shake to ensure secure contents
- Once the following steps are taken, continue installation by plugging in PID controller to approved outlet
- Set the injector head assembly onto coil stand prior to plugging in the coil to PID controller, finish installation by attaching the coil to controller
- Turn on controller to specified temperature and allow heat sink for 10-15 minutes before beginning session
Updated 5/25/22
Billy Yarr on Apr 14, 2023
I’ve had the B2 for about six months & Bzero I received in the last week & I can’t leave them be lol I could just can’t wait to get the 12v c PID controller and set up a station in the car lol
Bring on to B3 💨💨pass💨💨pass💨💨